Chapter 7: Operation; Operating Environment; Intended Use - Omron LD-250 User Manual

Platform
Hide thumbs Also See for LD-250:
Table of Contents

Advertisement

Before proceeding with any tasks described in this chapter, you should complete the pro-
cedures described in the Setup and Getting Started chapters, including map creation.

7.1 Operating Environment

Intended Use

The LD-250 is designed to operate in indoor industrial environments. In general, if a wheel-
chair user can safely and easily navigate the environment (open, and mostly flat with only
gentle inclines and wide doorways), then it is navigable by an LD-250.
!
The following guidelines apply:
Floor—Clean and dry floors that you sweep regularly and routinely keep free of debris,
l
dust, and liquids.
Typical Inclines—The LD-250 is intended to operate in a workspace that has a mostly
l
flat floor. If the workspace includes inclined areas, Omron recommends a gentle incline
typical of wheelchair ramps. Be aware that the payload structure and any loads trans-
ported can:
l
l
Inclines (Ramps)—With a properly designed and stable payload, the LD-250 can oper-
l
ate on ramps at full payload capacity. However, extended periods of operation on
ramps will affect battery duration and speed is limited to 600 mm/sec on inclines such
as ramps. Operational recommendations are:
1.7 degrees (3% grade)
3 degree slope
4.75 degrees (1:12 slope, typical wheelchair
ramp)
Temperature—5 to 40°C (41 to 104°F), with a recommended humidity range of 5% to
l
95%, non-condensing. Operating the LD-250 at high or low ambient temperatures (par-
ticularly with a full payload and high speeds) can cause the battery to exceed its oper-
ating temperature limits. If this happens, you are notified by escalating software
20472-000 Rev B
DANGER: PERSONAL INJURY RISK
There is risk of serious injury by crushing if the AMR tips over as a result of
improper operation on inclines that do not comply with the operating spe-
cifications.
Reduce the AMR's ability to traverse an incline.
Change its operating center of gravity (CG).
Slope
LD-250 Platform User's Guide

Chapter 7: Operation

Payload Restric-
tion
No restriction
200 kg
165 kg
Speed Limit
No restriction
600 mm/s
600 mm/s
113

Advertisement

Table of Contents
loading

Table of Contents