Table of Contents
Advertisement
Board Installation
Into Basic Hot-Swap
System
Into Full Hot-Swap or
High-Availability
System
Removal Procedure
Caution
2 - 20
1. Check board configuration, e.g. switch settings
2. Check that you are using an ACC/RTB-602, if applicable
3. PSB variant: Install board into node slot
Standard CompactPCI variant: Install board into peripheral slot
of powered system
4. Close handles
5. Fasten board with screws
6. Connect software manually according to system documentation
1. Check board configuration, e.g. switch settings
2. Check that you are using an ACC/RTB-602, if applicable
3. PSB variant: Install board into node slot
Standard CompactPCI variant: Install board into peripheral slot
of powered system
The hot-swap LED stays blue until the board software connection pro-
cess has been completed.
4. Close handles
5. Fasten board with screws
Before removing the board, observe the following:
• Board damage and data loss
Removing the board under hot-swap conditions from system slots,
causes board damage and data loss.
Therefore, only remove the board under hot-swap conditions if the
board is to be operated in slots for which hot swap is explicitly per-
mitted by the system documentation (in most hot-swap systems
peripheral slots only).
• Data loss
Removing the board from a powered system with IDE devices
attached to the board's primary or secondary IDE interface via the
ACC/RTB-602 results in data loss.
Only remove the board from a powered system without IDE devices
attached to the board's primary or secondary IDE interface via the
ACC/RTB-602.
Installation
PPC/CPCI-690
Advertisement
Table of Contents
