Table of Contents
Advertisement
Hardware Preparation and Installation
1
Processor Removal and Replacement
Replacing Lithium Batteries
1-28
Replace the chassis or system cover, reconnect the system to the AC or DC
power source, and turn the equipment power on.
Microprocessors in Motorola board products are factory-installed and
tested to ensure proper operation under board-specific BIOS software
within specified power and cooling requirements. Field replacement of the
processor is not recommended. A processor of a different type or with a
different stepping mask may not be supported by the BIOS. Also, faster
processors may alter cooling and power requirements beyond
specifications.
Motorola is continually improving its products to use the latest processor
speeds and technologies as they become available. If your application
requires a different processor, consult your local Motorola representative.
Follow these safety rules for proper battery operation and to reduce
equipment and personal injury hazards when handling lithium batteries.
Use the battery for its intended application only.
Note
Do not recharge, open, puncture or crush, incinerate, expose to
high temperatures or dispose of in your general trash collection.
To replace the lithium battery, observe the following guidelines and follow
the steps below.
Note
When replacing the battery, power must be applied to the board
to prevent data loss.
Computer Group Literature Center Web Site
Advertisement
Table of Contents
