Motorola PPC/CPCI-690 Reference Manual page 105

PowerBoot
eeprom_info
D
ESCRIPTION
S
YNTAX
P
ARAMETERS
E
XAMPLE
help
D
ESCRIPTION
S
YNTAX
P
ARAMETERS
E
XAMPLE
PPC/CPCI-690
Command to display all supported I2C EEPROMs on the board.
eeprom_info
None
PowerBoot> eeprom_info
MSG: EEPROM information list
ID_ROM_0
ID_ROM_1
ID_ROM_2
I2C_PCIBRIDGE_0
MSG: End of list
PowerBoot>
This command displays all commands with syntax provided by Power-
Boot.
help
None
PowerBoot> help
--- Command words ---
ATATEST - Test of ATA/IDE interface connection
AUTOBOOT - Init SETBOOT command parameter settings
BAUD - BAUD 600|1200|2400|4800|9600|19200|38400|115200
BF - BF <begin>,<end>,<value>[,B|W|L|P]
BM - BM <begin>,<end>,<destination>
BS - BS <begin>,<end>,[/]<value>[,B|W|L|P]
BT - BT <begin>,<end>,[e], [c]
BV - BV <begin>,<end>,<destination>
CACHE - CACHE <d,i,2> <e,d>
DEVSHOW - Show board device tree [1|2|3|4] [node] [verbose level]
DREAD - Read test to check caches
DRW - R/W test to check caches
DWRITE - Write test to check caches
EEPROM_INFO - Display information about EEPROMs
EEPROM_READ - <device> <offs> <byteCnt> [dstAddr]
EEPROM_WRITE - [-e] <device> [offs byteCnt srcAddr]
EXECUTE - EXECUTE <address>
16384 Byte: ID-ROM of the base board
256 Byte: ID-ROM of the RTB
256 Byte: ID-ROM of the IPMI
256 Byte: I2C-EEPROM of PCI-to-PCI Bridge
Command Set
4 - 31