Leds; Table 8 Description Of Front Panel Leds - Motorola PPC/CPCI-690 Reference Manual

Front Panel

LEDs

3 - 6
The front panel provides the following four LEDs:
Table 8: Description of Front Panel LEDs
LED Description
R/U1 Hardware-LED mode (default): Reset LED indicates board status
Green: Normal operation
Red:
User-LED mode (see "userled" page 4-26):
User LED 1 can be programmed to be red, green or OFF
E/U2 Hardware-LED mode (default): Blinking Ethernet LED indicates the sta-
tus of the Ethernet 1 (default), 2 and 3 interfaces respectively, depending
on configuration by software (programmable, see "userled" page 4-26).
Green: Ethernet link activity
OFF:
User-LED mode (programmable, see "userled" page 4-26):
User LED 2 can be programmed to be red, green or OFF
HS Hot swap LED: Indicates hot-swap status
Blue:
OFF:
SYS System controller LED
Yellow: Board is installed in a system slot and acts as system
OFF:
Reset is active
No link activity
Board is installed and may be removed from the system
Board must not be removed from the system
controller
Board is installed in a peripheral slot and acts as intelligent
I/O board
Controls, Indicators, and Connectors
PPC/CPCI-690