Board Installation
Board Installation
2 - 16
The board's front panel provides a compatibility glyph indicating whether
you use a CompactPCI standard or a PSB board variant:
Compatibility Glyphs for CompactPCI Standard and PSB Board Variants
Figure 7:
The standard CompactPCI board can be used either as system controller in
a system slot or as an intelligent I/O board in a peripheral slot. The PSB
variant must be installed into a node slot.
Both board variants provide hot-swap support, i.e. they may be installed in
or removed from a powered system. This section is divided into two sub-
sections for installing the board in a nonpowered system and in a powered
system supporting hot swap.
Note: EN 55022 Class A and FCC Part 15 Class A are achieved by using
single-point grounding. If you ground the CPCI-690 at multiple points
EMC problems may occur.
Installation
PPC/CPCI-690