Overview Of Start-Up Procedure; Table 1-1. Startup Overview - Motorola MCP750 Installation And Use Manual

Hardware Preparation and Installation
1

Overview of Start-up Procedure

Unpack the hardware.
Configure the hardware by setting jumpers on
the boards and transition modules.
Ensure CompactFLASH card is installed (if
required).
Ensure memory mezzanines are properly
installed on the board.
Install PMC Module (if required).
Install the MCP750 in the chassis.
Install transition module into chassis.
Connect any other devices or equipment used.
Power up the system.
Note that the debugger initializes the MCP750 Using the Debugger
Initialize the system clock.
Examine and/or change environmental
parameters.
Program the board as needed for your
applications.
1-4
The following table lists the tasks that you will need perform before using
this board. It also informs you where to find the information you need to
perform each step. Be sure to read this entire chapter (including all caution
and warning notes) before you begin.

Table 1-1. Startup Overview

Task Section or Manual Reference
Unpacking Instructions
MCP750 Base Board Preparation
TMCP700 Transition Module Preparation
Compact FLASH Memory Card Installation
RAM300 Memory Mezzanine Installation
PMC Module Installation
MCP750 Module Installation
TMCP700 Transition Module Installation
Chapter 4, Connector Pin Assignments
Refer also to the documentation provided with
the equipment.
Applying Power
You may also wish to obtain the PPCBug
Firmware Package User's Manual
Using PPCBug, Debugger
SET command
Chapter 6, CNFG and ENV Commands
MCP750 Series Single Board Computer
Programmer's Reference Guide, listed in
Appendix B, Related Documentation
Computer Group Literature Center Web Site
and
Commands, and the