Overview Of Start-Up Procedure; Table 2-1 Startup Overview; Table A-2 Manufacturers' Documents - Motorola CPCI-6020 Installation And Use Manual

Hardware Preparation and Installation
Shipment Inspection
To inspect the shipment, perform the following steps:
1. Verify that you have received all items of your shipment.
2. Check for damage and report any damage or differences to customer service.
3. Remove the desiccant bag shipped together with the board and dispose of it
according to your country's legislation.
The product is thoroughly inspected before shipment. If any damage occurred during
transportation or any items are missing, contact customer service immediately.
2.3

Overview of Start-up Procedure

The following table lists the things you will need to do before you can use this board and tells
you where to find the information you need to perform each step. Be sure to read this entire
chapter, including all Caution and Warning notes, before you begin.

Table 2-1 Startup Overview

Task
Unpack the hardware.
Configure the hardware by setting jumpers
on the boards.
Ensure CompactFlash card is installed (if
required).
Ensure memory mezzanines are properly
installed on the board.
Install PMC Module
(if required).
Install the CPCI-6020 in the chassis.
Install PIM on CPCI-6020-MCPTM-01
(if required)
Install peripherals, and any other devices or
equipment used.
Power up the system.
Ensure that the debugger initializes the
CPCI-6020
36
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Overview of Start-up Procedure
Page
Chapter 2, Unpacking and Inspecting the Board, on
page 35
Chapter 2, Jumper Settings, on page 41
Chapter 2, CompactFlash Memory Card Installation,
on page 46
Chapter 6, RAM500 Module Installation, on page 118
Chapter 2, PMC Module Installation, on page 44
Chapter 2, Installing and Removing a Module, on page
51
Chapter 7, Installing the PIM, on page 138
Appendix A, Manufacturers' Documents, on page 161
Chapter 2, Hardware Preparation and Installation
Chapter 5, Firmware