Switch Settings; Table 7 Switch Settings; Figure 6 Location Of Switches - Motorola PPC/CPCI-690 Reference Manual

Installation

Switch Settings

Caution
PPC/CPCI-690
The board provides three configuration switches, SW1, SW2, and SW4.
Figure 6: Location of Switches
For default settings, the white switches are moved to the OFF position.
• Board malfunction
Changing the setting of switches marked as 'reserved' causes the
board to malfunction.
Do not change the settings of switches marked as 'reserved' for they
might carry production-related functions.
• Boot block damage
If you change the boot flash write protection you may unintentionally
overwrite boot flash 2.
Only change the boot flash write protection if it is explicitly stated.
• Board damage
Setting/resetting the switches during operation causes board damage.
Therefore, check and change switch settings before you install the
board.
• Data loss and board malfunction
Disabling the PCI bus 0 reset and resetting the board when data trans-
fer via SENTINEL is performed result in data loss and malfunction of
the board.
Only operate the board with SW2-4 in its default position (OFF).
Switch Settings
2 - 13