Table of Contents
Advertisement
PowerBoot
netsave
D
ESCRIPTION
S
YNTAX
P
ARAMETERS
controller
filename
startAddr
endAddr
Ethernet#
targetIP#
serverIP#
E
1
XAMPLE
PPC/CPCI-690
This command saves a specified memory area via TFTP into a file located in a host
system. The file cannot be created, i.e. it must already exist on the host with correct
write permissions. NETSAVE overrides the content of the file. For creating a con-
nection to the server, the following 2 procedures are supported:
•
RARP (Reverse Address Resolution Protocol)
•
and ARP (Address Resolution Protocol).
For these protocols the CPU board is referred to as target.
netsave [-c controller] filename startAddr endAddr [<Ethernet#>]
[<targetIP#> <serverIP#>]
Specifies the Ethernet interface
Possible values are: ETH1, ETH2 and ETH3
Specifies the name of the file in the host system
Specifies the starting address of the memory area to be saved into the file
on the host.
Specifies the end address of the memory area to be saved into the file on the
host
Specifies the Ethernet address of the CPU board
Defines the Internet IP address of the CPU board (target) written in the fol-
lowing manner ggg.hhh.iii.kkk
Defines the Internet IP address of the server accessed for uploading the
TFTP file
PowerBoot> netsave test 100000 1fffff
PHY-Device at 100MB/s and full duplex negotiated
WANCOM MAC ADDRESS : 00:80:42:11:67:C2
Transmitting RARP-REQUEST... Reception of RARP-REPLY
Transmitting TFTP-REQUEST to server 00:80:42:10:5B:C7, IP
192.168.41.1
PACKET:2049 - saved $00100000..$001FFFFF (1048576 bytes)
PowerBoot>
Command Set
4 - 45
Advertisement
Table of Contents
