Fig. 2-12: Counter Tab On The Device Test Dialog Box - Advantech MIC-3716 Manual

Testing the Counter Function
Click the Counter Tab to bring its test panel forth. The counter
channel (Channel 0) offers two options: Event counting and Pulse out.
If you select Event counting, you need to first connect your clock
source to pin CNT0_CLK. The counter will start counting after the pin
CNT0_GATE is triggered. If you select Pulse Out, the clock source
will be output to pin CNT0_OUT. You can configure the Pulse
Frequency with the scroll bar.

Fig. 2-12: Counter tab on the Device Test dialog box

Only after your card device is properly set up, configured and tested,
can the device installation procedure be counted as complete. After the
device installation procedure is completed, you can safely proceed to
the next chapter, Signal Connections.
29