Mounting Dies - TE Connectivity AT-SC Operating Instructions Manual

528050-1
- Install the lower die holder in the same manner
as the upper one.
- Slightly tighten the T-Bolt by turning the
hole-nut counter clock wise. (Fig. 9.04)
9.2

Mounting Dies

DANGER!
Due to the risk of hand or finger injury, never try to reach into the machine before
having assured that the machine is disconnected from the air supply. Disconnect the
air supply before changing the adapter or the dies.
CAUTION!
 The crimp machine is only allowed to be used with mounted adapter and die set.
 The crimp machine is only allowed to be used when it is in complete functional
condition.
 When working with the Pneum. Parallel Crimp Machine AT-SC, do not wear loose
clothing, jewellery or long, loose hair that can get caught in the Pneum. Parallel
Crimp Machine AT-SC.
 Work with caution.
 Only trained personal are allowed to work on or with the machine.
Page 51 / 101
412-18876 Rev. G
Fig. 9.03
Fig. 9.04
ECOC: EGC0 ; LOC: AI