528050-1
9
Tooling
9.1
Upper and Lower SDE Adapter (Standard Adapter) Assembly
DANGER!
Due to the risk of hand or finger injury, never try to reach into the machine before
having assured that the machine is disconnected from the air supply. Disconnect the
air supply before changing the adapter or the dies.
CAUTION!
The crimp machine is only allowed to be used with mounted adapter and die set.
The crimp machine is only allowed to be used when it is in complete functional
condition.
When working with the Pneum. Parallel Crimp Machine AT-SC, do not wear loose
clothing, jewellery or long, loose hair that can get caught in the Pneum. Parallel
Crimp Machine AT-SC.
Work with caution.
Only trained personal are allowed to work on or with the machine.
-
Disconnect air supply.
-
Loosen on one side the screw of the sliding
plates with the 2mm hex key and slide the
plates to the side. (Fig. 9.01)
-
Now slide the upper die holder on to the T-Bolt.
-
Slide the plates back and finger tighten the
screws.
-
Slightly tighten the T-Bolt by turning the
hole-nut clock wise. (Fig. 9.02)
Page 50 / 101
412-18876 Rev. G
Fig. 9.01
Fig. 9.02
ECOC: EGC0 ; LOC: AI