Table of Contents
Advertisement
Available languages
Available languages
528050-1
4.4
Hazardous Areas
1.
Hazardous Area: Area of interchangeable crimping dies
Person at risk:
Type of Hazard:
2.
Hazardous Area: Opened Machine
Person at risk:
Type of Hazard:
4.5
Safety Precautions
Please observe the national reglementations according to the minimum age of the personnel operating
the Pneum. Parallel Crimp Machine AT-SC. Allowing younger persons access to the machine is strictly
prohibited.
O
Exercise caution at any time when the Pneum. Parallel Crimp Machine AT-SC is switched on.
O
Operate the Pneum. Parallel Crimp Machine AT-SC in a dry and dust free environment only.
The crimp machine is only allowed to be used when it is in complete functional condition.
O
When working with the Pneum. Parallel Crimp Machine AT-SC, do not wear loose clothing,
jewellery or long, loose hair that can get caught in the Pneum. Parallel Crimp Machine AT-SC.
O
Prior to starting up the Pneum. Parallel Crimp Machine AT-SC, make sure it is firmly positioned
on a sturdy stand or bench to prevent it from tipping over.
O
Disconnect the Pneum. Parallel Crimp Machine AT-SC from the air supply before attempting
any maintenance work. Due to the risk of hand or finger injury, never try to reach into the
machine before having assured that the machine is disconnected from the air supply.
O
Check the release button before starting the work on the crimp machine.
O
Do not modify the Pneum. Parallel Crimp Machine AT-SC nor use it for any purpose for which it
was not intended.
O
Do not operate the Pneum. Parallel Crimp Machine AT-SC until you have studied and fully
understood all the instructions described in this instruction manual.
O
In cases of a machine malfunction, production must be stopped and the malfunction must be
fixed before continuing work with the machine.
O
In the case of imminent danger immediately press the release button. The release button must
be within the direct reach of the operator. It must not be covered.
O
Maintenance work may be performed only by authorized and properly trained personnel.
O
The Pneum. Parallel Crimp Machine AT-SC has to carry handles for the transport by hand.
Wear safety shoes during the transport of the machine.
O
The Pneum. Parallel Crimp Machine AT-SC is not allowed to be used without a mounted
adapter.
O
For maintenance work wear adequate protective gloves and safety glasses.
O
Only one person is allowed to work on or with the machine.
O
Only trained personal are allowed to work on or with the machine.
O
It is only allowed to work with the specified working pressure.
Operator
Hand Injuries
Installation Engineer
Direct or indirect contact with movable parts of the machine,
Hand injuries (cuts from sharp edges)
Hand injuries (risk of crushing)
Page 42 / 101
412-18876 Rev. G
ECOC: EGC0 ; LOC: AI
Advertisement
Chapters
Table of Contents
