Basic Safety Instructions; Responsibilities; Notes On Setting Up And Operating The Machine - TE Connectivity AT-SC Operating Instructions Manual

528050-1
2

Basic Safety Instructions

The Pneum. Parallel Crimp Machine AT-SC has been constructed according to state-of-the-art
technology and the acknowledged technical safety regulations.
When carrying out jobs such as installation, putting the machine into operation or setting it up, operation,
changing the conditions of use and the mode of operation or carrying out maintenance and service jobs, it
is important to observe the procedures for switching off the machine described in the operation manual.
RoHS Information:
Information on the presence and location of any substances subject to RoHS (Restriction on Hazardous
Substances) can be found at the following website:
http: // www.tycoelectronics.com/customersupport/rohssupportcenter/
Click on "Find Compliance Status" and enter equipment part number.
2.1

Responsibilities

The Pneum. Parallel Crimp Machine AT-SC may only be operated by suitably trained and authorized
personnel. The user must clearly define and observe the responsibilities of the personnel for operation,
set-up, maintenance and service.
It is particularly important to define who is responsible for work on the pneumatic equipment. Such work
should only be carried out by specially trained staff.
Should the user make any changes to the machine without consulting the manufacturers or the suppliers,
the latter will not be liable for any damage that may result.
2.2

Notes on Setting Up and Operating the Machine

The Pneum. Parallel Crimp Machine AT-SC may only be set up and operated in perfect technical
condition, observing all the safety regulations and considering any possible dangers. Before
commissioning the machine, it is always important to check whether all safety devices are functioning
correctly and whether the adapter and the die set are mounted.
The housing and the covers in particular may only be removed by specially trained personnel.
Adapter and die set are only allowed to be removed when the machine is not in operation and has been
disconnected from the air supply.
If you suspect that the machine cannot be operated safely, it must be switched off and secured against
anyone accidentally switching it on.
The machine may only be used for the purpose specified in the operating manual.
The manufacturers and suppliers will not be liable for any damages which may result due to the machine
being used for a purpose other than that for which it was intended. This is done entirely at the user's own
risk.
Page 39 / 101
412-18876 Rev. G
ECOC: EGC0 ; LOC: AI