Figure 3. Removing The Brackets And Shipping Pad - Eaton 9355 Series User Manual

Figure 3. Removing the Brackets and Shipping Pad

Stabilizing Bracket
M10 Bolts
M4 Screws
7. Reinstall the front cover removed in
Hang the top edge of the cover on the cabinet first, then lower the bottom edge and snap into place.
NOTE Support the front and back of the cabinet when rolling it off the pallet to prevent tipping.
8. Slowly roll the cabinet toward the rear of the pallet. Once the pallet tilts, continue rolling the cabinet down
the pallet until the cabinet touches the floor (see
If needed, adjust the leveling feet so that the cabinet rolls freely.
Front Shipping
Bracket
M10 Bolts
Pallet Bracket (x2)
(Secures the rear UPS
leveling feet to the pallet)
Shipping Pad
Step 4.
Figure 4).
Eaton 9355 Parallel UPS (10/15 kVA) User's Guide 164201601—Rev E0
UPS System Installation
15