Figure 2. Removing The Stabilizing Bracket Bolts - Eaton 9355 Series User Manual

UPS System Installation

Figure 2. Removing the Stabilizing Bracket Bolts

2. Remove the M10 bolts from the two Pallet Brackets securing the leveling feet to the pallet (see
3. Remove the four M4 screws securing the stabilizing bracket to the cabinet rear panel and remove the
bracket (see
NOTE
4. Remove the front cover from the bottom cabinet to access the front shipping bracket.
Press and release the handle latch at the bottom of the cover and then lift the cover up and off the cabinet.
5. Remove the three M10 bolts securing the rear shipping pad to the pallet and remove the shipping pad.
NOTE
6. Remove the two M10 bolts securing the front shipping bracket and remove the bracket.
If needed, adjust the leveling feet to release the bracket.
14 Eaton 9355 Parallel UPS (10/15 kVA) User's Guide 164201601—Rev E0
Figure 3). Retain the hardware for later use.
Retain the stabilizing bracket and hardware for later re-assembly onto the cabinet
Hold the back of the cabinet so that the bolts can be removed easily without the cabinet
rolling backward.
M10 Bolts
Figure 3).