Initial Startup - Eaton 9355 Series User Manual

Parallel ups 10/15 kva
Table of Contents

Advertisement

Operation
Table 6. User Settings (Continued)
Description
Battery Capacity
Battery Low Alarm Level
Bypass Voltage High Limit
Bypass Voltage Low Limit
Nominal Output Frequency
Synchronization
Synchronization Window
Unsynchronized Transfer to Bypass
Output Frequency Slew Rate
Usage of Bypass
Transfer to Bypass When Overload
Automatic Start Delay
Control Commands from X-Slot1
Control Commands from X-Slot2/Serv
X-Slot Signal Input Activation Delay
Input signal delayed shutdown delay
Site Wiring Fault Notice
Reset Custom Event Settings
Auto Output Configuration
6 6 . . 2 2
I I n n i i t t i i a a l l S S t t a a r r t t u u p p
Startup and operational checks must be performed by an authorized Eaton Customer Service Engineer, or the
warranty terms specified on the product's resources page become void. See
This service is offered as part of the sales contract for the UPS. Contact an Eaton service representative in
advance (a minimum two-week notice is required) to reserve a preferred startup date.
Only qualified service personnel (such as a licensed electrician) should perform the UPS installation. Initial
startup must be performed by an authorized Eaton Customer Service Engineer. Risk of electrical shock.
52
Eaton 9355 Parallel UPS (10/15 kVA) User's Guide 164201601—Rev E0
Available Settings
(see
6.3 Configuring the UPS for
1 through 65535 watts per cell
1.750 through 1.950 volts per cell
+1 through +20% (1% increments)
-1 through -20% (1% increments)
50 Hz or 60 Hz
Enabled/Disabled
±0.5 through ±3.0 Hz
(0.1 Hz increments)
Allowed/Not Allowed
0.1 though 5 hertz per second
(0.1 Hz increments)
Enabled/Disabled
After a delay/Immediately
-1 through 32767 seconds
(-1 means disabled)
Allowed/Disabled
Allowed/Disabled
0 through 65 seconds
1 through 65535 seconds
Enabled/Disabled
0 through 32
Enabled/Disabled
WARNING
Default Setting
EBMs)
4 strings for UPS-64 models
34 W/cell
1.880 V/cell
120V +10%
120V -15%
60 Hz
Enabled
±2.0 Hz
Not Allowed
0.5 Hz/s
Enabled
After a delay
0s
Allowed
Allowed
5s
120s
Enabled
Total: 0/32
Enabled for initial startup
Disabled after initial startup
Chapter 8 Warranty
for details.

Advertisement

Table of Contents
loading

Table of Contents