Figure 3. Removing The Brackets And Shipping Pad - Eaton 9155 User Manual

Figure 3. Removing the Brackets and Shipping Pad

Front Shipping
Bracket
M10 Bolts
Pallet Bracket (x2)
(Secures the rear UPS
leveling feet to the pallet)
Shipping Pad
7. Reinstall the front cover removed in
Hang the top edge of the cover on the cabinet first, then lower the bottom edge and snap into place.
NOTE Be sure to support the front and back of the cabinet when rolling it off the pallet to
prevent tipping.
8. Slowly roll the cabinet toward the rear of the pallet. Once the pallet tilts, continue rolling the cabinet down
the pallet until the cabinet touches the floor (see
If needed, adjust the leveling feet so that the cabinet will roll.
Stabilizing Bracket
Step 4.
Figure 4).
Eaton 9155 Parallel UPS (8–15 kVA) User's Guide 164201592—Rev E0
Parallel UPS System Installation
M10 Bolts
M4 Screws
17