Figure 8. Removing The Front Shipping Bracket And Shipping Pad - Eaton 9355 Series User Manual

UPS System Installation
8. Remove the two M10 bolts securing the front shipping bracket and remove the bracket.
If needed, adjust the leveling feet to release the bracket.

Figure 8. Removing the Front Shipping Bracket and Shipping Pad

9. Reinstall the front cover removed in
Hang the top edge of the cover on the cabinet first, then lower the bottom edge and snap into place.
NOTE
10. Slowly roll the cabinet toward the rear of the pallet. Once the pallet tilts, continue rolling the cabinet down
the pallet until the cabinet touches the floor (see
If needed, adjust the leveling feet so that the cabinet rolls freely.
18 Eaton 9355 Parallel UPS (10/15 kVA) User's Guide 164201601—Rev E0
M10 Bolts
Step
Support the front and back of the cabinet when rolling it off the pallet to prevent tipping.
Front Shipping
Bracket
M10 Bolts
Shipping Pad
6.
Figure 9).