Changing And Displaying A Fixed Value - DANIEL 2500 User's Reference Manual

______________________________________________________ MODEL ______________________________________________________

CHANGING AND DISPLAYING A FIXED VALUE

The steps involved in changing and displaying a FIXED value on the MODEL
2500 LCD screen are as follows:
- Begin with the following illustrated display screen message.
- Press the DOWN arrow key to move to the third selection of the
C3TEMP menu and display the FIXED value of the variable as
illustrated in the following display screen.
The status field has changed from LIVE to FIXED, and the
operator-entered value (30.0 DEGF) has replaced the value being sent
by the transmitter (20.0 DEGF).
If the password has been entered, the operator may change this value
by keying in a new value and then pressing the ENTER key. If an
error is made while keying in the new value, the DOWN arrow key
may be used to backspace the cursor over the error.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
94
C3TEMP LIVE
20.0 DEGF
C3TEMP FIXED
30.0 DEGF
MODEL 2500 2500
SECTION 6 6 SECTION