DANIEL 2500 User's Reference Manual page 156

______________________________________________________ MODEL ______________________________________________________
ENTRY
TAPLOC#
TAPTYPE#
TESTPULS
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
142
EXPLANATION
-T-
TAPLOC# provides for choosing the tap location for
orifice meter runs. Multiple runs may be designated by
number or letter suffixes (accompanied with the symbol
# in TAPLOC#). For example, TAPLOC1 is the variable
name used to select the tap location for run number 1.
The selections for TAPLOC# are UPSTREAM and
DNSTREAM (downstream).
TAPTYPE provides an operator selection entry for
choosing the tap type for orifice meter runs. The
selections for TAPTYPE# are pipe and flange.
TESTPULS provides a turbine meter test signal. The
selections are ON, which initiates the test signal, and
OFF, which turns off the signal.
MODEL 2500 2500
APPENDIX C C APPENDIX