Model 2500 Display Screen - DANIEL 2500 User's Reference Manual

MODEL 2500_______________________________________________________ MODEL 2500_______________________________________________________

MODEL 2500 DISPLAY SCREEN

The DANIEL INDUSTRIES MODEL 2500 INSTRUMENTATION SYSTEM
MICROCOMPUTER front panel has a LCD screen located at the top of the front
panel which is electro-luminescent backlighted for readability under various
ambient lighting conditions.
This screen displays two lines of alphanumeric characters with 16 characters in
each line, which provide for the readout of data, system command and prompts,
and computation results. Numeric values are displayed in appropriate engineering
units when applicable.
The display also has an adjustable viewing angle so that instruments, which are
mounted either at a relatively low or high height, may be adjusted for comfortable
viewing.
To adjust the LCD for comfortable viewing after installation:
- Release the catch located at the bottom of the panel
- Pull the display unit forward approximately one inch
- Locate the small potentiometer on the left hand side of the display
board in the center, approximately 1/2 " from the front, as illustrated
below. With a small screwdriver adjust the angle for the most
comfortable viewing.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
SECTION 2 2 SECTION
9