DANIEL 2500 User's Reference Manual page 72

______________________________________________________ MODEL ______________________________________________________
Logs are printed on the serial port selected for REPORTS. Five selection
entries are provided for the LOGGER command. They are shown in the chart
below:
Selection
NO LOG
ALRM SET
ALRM S/R
OPCHANGE
ALRM&OPR
Log formats are illustrated below:
ALARM SET Logging:
------------------------------------------------------------------------------------------------------------
53301510
TEMP LO-LO LIMIT
------------------------------------------------------------------------------------------------------------
ALARM RESET Logging:
------------------------------------------------------------------------------------------------------------
53301510
TEMP LO-LO LIMIT
------------------------------------------------------------------------------------------------------------
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
58
No logging is performed.
Alarm set logging is performed.
Alarm set and reset logging is performed.
Operator change logging is performed.
ALRM S/R and OPCHANGE selections are
combined.
UNIT:0000 ALARM SET LOGGER
=
UNIT:0000 ALARM RESET LOGGER JAN 13 1987 09:14
=
2500 Operation
-2 -3.
-2 103.
MODEL 2500 2500
JAN 13 1987 09:14
SECTION 4 4 SECTION