High Speed Settings - Cycle832 - Siemens Sinumerik 840D sl Programming Manual

Programming cycles externally
16.1 Technology cycles
16.1.38

High Speed Settings - CYCLE832

Programming
CYCLE832(_TOL, _TOLM, _V832)
Note
CYCLE832 does not relieve the machine manufacturer from optimization tasks that are
necessary when commissioning the machine. This involves the optimization of the axes
involved in the machining process and NCU settings (pre-control, jerk limiting, etc.).
Parameters
Param Param
No.
Mask intern
1
TOL _TOL
2 _TOLM
3 _V832
Note
When CYCLE832 is deselected, the tolerance parameter must be transferred with zero.
Example: CYCLE832(0,0,1)
The syntax CYCLE832() is also permitted for deselecting CYCLE832.
822
Explanation
Tolerance
Technology
UNITS:
0 = Deselection
1 = Finishing
2 = Semi-finishing
3 = Roughing
Version CYCLE832
UNITS:
0 = up to software version 7.5
1 = from HMI sl software version 2.6 onward
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Job planning