Siemens Sinumerik 840D sl Programming Manual page 601

DO FTOC:
Note
FTOCON must be activated in the destination channel.
Job planning
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Execute the "Continuous modal write of online tool offset" function
Parameter:
<function>:
<reference
value>:
<tool parameter:
<channel>:
<spindle>:
Motion synchronous actions
10.4 Actions in synchronized actions
Number of the polynomial function
Type: INT
Range of 1 to 3
values:
Note:
Must match the setting for FCTDEF.
Main run variable for which a function value is to
be calculated using the polynomial function
defined with FCTDEF.
Type: VAR REAL
Number of the wear parameter (length 1, 2 or 3)
in which the offset value is to be added.
Type: INT
Number of the channel in which the online tool
offset is to take effect.
Type: INT
Note:
A channel number only has to be specified if the
offset is not to take effect in the active channel.
Number of the spindle for which the online tool
offset is to take effect.
Type: INT
Note:
A spindle number only has to be specified if the
offset is to be applied to a non-active grinding
wheel rather than the active tool which is currently
in use.
601