Axis couplings
9.4 Electronic gear (EG)
Version 3:
Syntax
EGOFC(following
spindle1)
Note
This version is only permitted for spindles.
9.4.4
Deleting the definition of an electronic gear (EGDEL)
Function
An EG axis group must be switched-out before its definition can be deleted.
Programming
Syntax
EGDEL(following
axis)
9.4.5
Rotational feedrate (G95) / electronic gear (FPR)
Function
The FPR command can be used to specify the following axis of an electronic gear as the axis,
which determines the revolutional feedrate. Please note the following with respect to this
command:
•
The feedrate is determined by the setpoint velocity of the following axis of the electronic
gear.
•
The setpoint velocity is calculated from the speeds of the leading spindles and modulo
axes (which are not path axes) and from their associated coupling factors.
•
Speed parts of linear or non-modulo leading axes and overlaid movement of the following
axis are not taken into account.
542
Description
The electronic gear is deactivated. The following spindle
continues to traverse at the speed/velocity that applied at
the instant of deactivation. This call triggers a preprocessing
stop.
Significance
The coupling definition of the axis group is deleted. Additional
axis groups can be defined by means of EGDEF until the
maximum number of simultaneously activated axis groups is
reached. This call triggers a preprocessing stop.
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Job planning