Multiple-Edge - Cycle79 - Siemens Sinumerik 840D sl Programming Manual

Programming cycles externally
16.1 Technology cycles
16.1.19

Multiple-edge - CYCLE79

Programming
CYCLE79(REAL _RTP, REAL _RFP, REAL _SDIS, REAL _DP, INT _NUM, REAL
_SWL, REAL _PA, REAL _PO, REAL _STA, REAL _RC, REAL _AP1, REAL _MIDA,
REAL _MID, REAL _FAL, REAL _FALD, REAL _FFP1, INT _CDIR, INT _VARI,
REAL _FS, REAL _ZFS, INT _GMODE, INT _DMODE, INT _AMODE)
Parameters
Param Param
No.
Mask intern
1
RP _RTP
2
Z0 _RFP
3
SC _SDIS
4
Z1 _DP
5
N _NUM
6
SW/L _SWL
7
X0 _PA
8
Y0 _PO
9
α0
_STA
10
R1/FS1 _RC
11 ∅
_AP1
12
DXY _MIDA
13
DZ _MID
14
UXY _FAL
15
UZ _FALD
16
F _FFP1
17
_CDIR
774
Explanation
Retraction plane (abs)
Reference point of tool axis (abs)
Safety clearance (to be added to reference point, enter without sign)
Multiple-edge depth (abs/inc), see _AMODE
Number of edges (1...n)
Width across flats or edge length (depending on _VARI)
("SW" for width across flats, "L" for edge length)
Width across flats only if even no.of edges, and single edge
Spigot reference point, 1st axis (abs)
Spigot reference point, 2nd axis (abs)
Angle of rotation, center of edge against 1st axis (X axis)
Corner rounding with _NUM > 2 (radius/chamfer, see _AMODE) (inc, to be entered without
sign)
("R1" for radius, "FS1" for chamfer)
Unmachined diameter of spigot
Maximum infeed width (for unit, see _AMODE)
Maximum depth infeed
Finishing allowance, plane
Finishing allowance, depth
Machining feedrate
Milling direction
0 = Climbing
1 = Conventional
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Job planning