Deep-Hole Drilling - Cycle83 - Siemens Sinumerik 840D sl Programming Manual

Programming cycles externally
16.1 Technology cycles
16.1.5

Deep-hole drilling - CYCLE83

Programming
CYCLE83(REAL RTP, REAL RFP, REAL SDIS, REAL DP, REAL DPR, REAL FDEP,
REAL FDPR, REAL _DAM, REAL DTB, REAL DTS, REAL FRF, INT VARI,
INT _AXN, REAL _MDEP, REAL _VRT, REAL _DTD, REAL _DIS1, INT _GMODE,
INT _DMODE, INT _AMODE)
Parameters
No. Param Mask Param intern
1
RP RTP
2
Z0 RFP
3
SC SDIS
4
Z1 DP
5
Z1 DPR
6
D FDEP
7
D FDPR
8
DF _DAM
9
DTB DTB
10
DTS DTS
11
FD1 FRF
12
VARI
13
_AXN
14
V1 _MDEP
15
V2 _VRT
16
DT _DTD
17
V3 _DIS1
18
_GMODE
748
Explanation
Retraction plane (abs)
Reference point (abs)
Safety clearance (to be added to reference point, enter without sign)
Final drilling depth (abs), see _AMODE
Final drilling depth (inc), see _AMODE
1. Drilling depth (abs), see _AMODE
1. Drilling depth (inc), see _AMODE
Amount/percentage for each additional infeed (degression amount/percentage), see
_AMODE
Dwell time at drilling depth, see _AMODE
Dwell time at start point (for swarf removal only), see _AMODE
Percentage for the feedrate for the first infeed, see _AMODE
Machining type
UNITS: Chip breaking / deswarfing
0 = Chip breaking
1 = Swarf removal
Tool axis:
0 = 3. Geometry axis
1 = 1. Geometry axis
2 = 2. Geometry axis
> 2 = 3. Geometry axis
Minimum infeed (only for degression percentage)
Retraction distance after each machining step (for chip breaking only)
> 0 = variable retraction distance
0 = Standard value 1 mm
Dwell time at final drilling depth, see _AMODE
Limit distance (for swarf removal only), see _AMODE
Geometrical mode (evaluation of programmed geometrical data)
UNITS: Reserved
TENS: Drilling depth with respect to tip/shank
0 = Tip
1 = Shank
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Job planning