Siemens Sinumerik 840D sl Programming Manual page 27

<init_time>:
<phys_unit>:
<limit values>:
<access rights>: Access rights for reading/writing GUD via part program or OPI
<name>:
[<value_1>,
<value_2>,
<value_3>]:
<init_value>:
Job planning
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Point in time at which the variable is reinitialized (optional)
Power On
INIPO:
End of main program, NC reset or Power On
INIRE:
NewConfig or end of main program, NC reset or
INICF:
Power On
End of main program, NC reset following local
PRLOC:
change or Power On
See "Attribute: Initialization value [Page 34]"
Physical unit (optional)
PHU <unit>:
See "Attribute: Physical unit (PHU) [Page 39]"
Lower and upper limit value (optional)
LLI <limit value>:
ULI <limit value>:
See "Attribute: Limit values (LLI, ULI) [Page 37]"
(optional)
APRP <protection level>: Read: Part program
APWP <protection level>: Write: Part program
APRB <protection level>: Read: OPI
APWB <protection level>: Write: OPI
See "Attribute: Access rights (APR, APW, APRP, APWP, APRB,
APWB) [Page 41]"
Name of variable
Note
• A maximum of 31 characters
• The first two characters must be a letter and/or an underscore.
• The $ sign is reserved for system variables and must not be
used.
Specification of array sizes for 1- to max. 3-dimensional array
variables (optional)
Initialization value (optional)
See "Attribute: Initialization value [Page 34]"
For the initialization of array variables:
See "Definition and initialization of array variables (DEF, SET, REP)
[Page 47]"
Flexible NC programming
Lower limit value (lower limit)
Upper limit value (upper limit)
Protection level Range of values: 0 ... 7
1.1 Variables
27