High Speed Cutting (Hsc) - Cycle_Hsc - Siemens Sinumerik 840D sl Programming Manual

16.1.39

High speed cutting (HSC) - CYCLE_HSC

Programming
CYCLE_HSC(_Mode, _TOL, _RTOL)
Parameters
Param Param
No.
Mask intern
1 _MODE
2 _TOL
3 _RTOL
Note
CYCLE_HSC internally calls CYCLE832 (High Speed Settings).
Note
No additional parameters have to be specified when deselecting CYCLE_HSC.
Example: CYCLE_HSC("OFF")
Example
Program code
G710
TRAORI
CYCLE_HSC("FINISH",0.01,3)
Job planning
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Explanation
Machining type (technology)
The machining type parameter is transferred in plain text as string to CYCLE_HSC ( upper and
lower case notation is permitted).
"FINISH" =
"SEMIFINISH" =
"ROUGH" =
"OFF" or "DESELECT" =
Tolerance
The tolerance corresponds to the axis tolerance of the geometry axis.
Rotary axis tolerance
The rotary axis tolerance is transferred to the NC using the OTOL=_RTOL command.
OTOL is only effective when orientation transformation is active (TRAORI).
Finishing
Rough-finishing
Roughing
Deselect CYCLE_HSC
Comment
; Machining type FINISH with 0.01 mm tolerance of
the geometry axes and 3 degrees rotary axis
tolerance.
Programming cycles externally
16.1 Technology cycles
823