Configuring your drive project
4.1
Restoring the factory settings
In order to restore the drive to a defined state, it is recommended that you reset the drive
parameters to their "factory settings" or defaults before the drive is commissioned.
Sequence
1. Select the menu command Project > Connect to target system.
The window "Target Device Selection" opens and displays a list of the detected drive
units.
2. Activate the check box " S120_CU320_2_DP " and click on "OK".
The PG/PC establishes the link to the Control Unit. It then performs an "Online/offline
comparison". The result is displayed in a window.
3. Click on the "Close" button in the results window.
Getting Started
Getting Started, 11/2009, 6SL3097-4AG00-0BP0
All manuals and user guides at all-guides.com
4
21