Before Mounting The G350; Mounting The G350 In The Rack; Mounting The G350 On A Wall; Attaching Brackets To The G350 For Wall Mounting - Avaya G350 Installing And Upgrading

Installing the Avaya G350 Media Gateway

Before mounting the G350

Ensure that the rack is bolted to the floor and is earthquake-protected, if required. If the
●
rack is not securely fixed in place, do not proceed with the installation.
If the G350 is being mounted in a rack with other equipment already installed, the G350
●
must be positioned to avoid imbalance.
Note:
The G350 weighs 22.5 pounds (10 kg) empty and between 33 and 35 pounds
Note:
(between 15 and 16 kg) when equipped with media modules. Two people may be
needed to mount the G350 Media Gateway in the rack.

Mounting the G350 in the rack

1. Position the G350 in the rack. Ensure that there is adequate ventilation.
2. Verify that the screw holes are aligned with the rack hole positions.
3. Insert two rack mounting screws, one on each side.
4. Verify that the G350 is level and horizontal.
5. Tighten the rack mounting screws. Avoid overtightening.
6. Verify that ventilation vents are not obstructed.
At this point, you have mounted the G350 chassis in the rack and are ready to insert media
modules as required in the planning documentation.

Mounting the G350 on a wall

To mount the G350 on a wall, use the two mounting brackets without cable guides. You can also
add a mounting bracket with cable guides if desired, as explained in
guides on page 27.

Attaching brackets to the G350 for wall mounting

Attach a bracket to each side of the G350, as shown in
28 Installation and Upgrades for the Avaya G350 Media Gateway
Brackets with cable
Figure 4.