Brackets With Cable Guides; Attaching Each Mounting Bracket To The G350 - Avaya G350 Installing And Upgrading

Brackets with cable guides

You can attach the mounting bracket with cable guides to the front of the G350 on one side, as
shown in the following figure. If you are fastening the chassis to the rack at the front, use the
mounting bracket with cable guides as one of the two front brackets. If you are fastening the
chassis to the rack at the middle, use the mounting bracket with cable guides at the front of the
chassis, in addition to the two regular mounting brackets on the sides of the chassis. In this
case, the mounting bracket with cable guides serves for cable management only — you do not
fasten it to the rack.
Note:
If you are installing an MM717 or MM716 media module, attach the mounting
Note:
bracket with cable guides to the right side of the rack, to support the weight of the
amphenol cable you will connect to the MM717 media module. See
DCP telephone to an MM312, MM712, or MM717 media module
Figure 3: Attaching a mounting bracket with cable guides

Attaching each mounting bracket to the G350

The G350 is held in place by mounting screws through the two mounting ears. Fill racks from
the bottom; that is, mount units in the lower positions first, to avoid balancing problems and
cabling complications.
1. Position a bracket over the desired mounting position.
2. Affix the bracket to the chassis with three of the nine 6-32 x 3/8 screws provided.
3. Tighten with a screwdriver.
Step 1: Mounting the G350 chassis
Connecting a
on page 51.
Issue 7 November 2009 27