Inserting The S8300 Server - Avaya G350 Installing And Upgrading

Inserting the S8300 Server

The S8300 can only be inserted in slot V1 on the left side of the G350 Media Gateway.
ELECTROSTATIC ALERT:
Hold media modules only by the edges to avoid damage from static electricity. Do
ELECTROSTATIC ALERT:
not touch the top or bottom of the circuit board. If possible, wear an anti-static
wrist-strap and use an anti-static bag.
!
CAUTION:
The connector pins can be bent or damaged if the module is handled roughly, or if
CAUTION:
misaligned and then forced into position.
!
CAUTION:
Separate ESD paths to the chassis ground connect to the media modules at the
CAUTION:
spring-loaded captive screws. Use a screwdriver to ensure the captive screws are
securely tightened to prevent damage to the equipment.
1. emove the plate between slots V1 and V2, labelled "Remove before removing or inserting
S8300 module".
2. Remove the blank plate from slot V1.
3. Position the server before the V1 bay opening and engage both sides of the module in the
interior guides.
4. Slide the S8300 Server slowly into the chassis, maintaining an even pressure to assure
that the module does not become twisted or disengaged from the guides.
Step 2: Installing the media modules
Issue 7 November 2009 33