Siemens SINAMICS V20 Series Operating Instructions Manual page 146

Parameter list
7.2 Parameter list
Parameter Function
2-wire control
•
using ON_FWD and ON_REV as permanent signals
3-wire control
•
using STOP as permanent signal, FWD and REVP as pulses
3 wire control
•
using OFF1 / HOLD and REV as permanent signal, ON as pulse signal
0
1
2
3
146
Range Factory
default
Siemens (start / dir)
2-wire (fwd / rev)
3-wire (fwd / rev)
3-wire (start / dir)
Can be Scaling
changed
Operating Instructions, 07/2012, A5E03728167
Data Data Acc.
set type Level
SINAMICS V20 Inverter