Fitting Onto A Hat Rail - Festo CPX-MMI-1 Electronic Manual

2. Fitting
2.1.3

Fitting onto a hat rail

Fitting
1
Suppor t
2
Fixing bolts
3
Clip
4
Hat rail
5
Clamping
element with
locking screw
Fig. 2/5: Side view: Fitting onto a hat rail
Festo P.BE−CPX−MM I−1−EN en 0305NH
For this method of fitting, the support must be mounted
firmly on a hat rail (support rail as per DIN 50022 − 35x7.5 or
DIN 50022 − 35x15).
Proceed with the hat rail fitting as follows:
1. Fit the clip (3), as shown below, onto the support type
CPX−MMI−1−H (1) with the M3x6 countersunk screws sup
plied. Tightening torque max. 0.6 Nm. Make sure that the
fixing bolts (2) of the bracket grip into the groove of the
support.
1 2
2. Hang the support onto the hat rail.
3. Secure the support with the clamping element (5) so that
it cannot tilt or slide down. In order to do this turn the
locking screw in a clockwise direction (see also following
diagram).
3
4
5
2−9