Installing Software To The Hdd - Advantech PPC-100 Manual

2.4 Installing Software to the HDD

Installing software requires an installed HDD. Software can be loaded in
the PPC-100 using three methods:
Method 1: Use Ethernet
You can use the Ethernet port to download software to the HDD.
Method 2: Use a FDD
The FDD port is located on the rear panel. Unscrew the two screws and
detach the iron piece. Attach a cable and power signal to the FDD port,
and attach to a FDD. Insert a 3.5" disk containing the software and
consult your software manual for installation procedures.
Method 3: Use the COM or parallel port
You can use Lap Link 6 or similar transmission software. Connect
another PC to the PPC-100 with an appropriate cable and transmit the
software to the PPC-100.
Chapter 2 System Setup 17