Advantech PPC-100 Manual page 69

These drivers are designed to work with Lotus 1-2-3 versions 2.0, 2.01
and 2.2, and with Lotus Symphony versions 1.0 and 1.1.
Step 1: Place the display driver diskette into drive A. Make A the default
drive by typing A: <ENTER>. Run the SETUP program by typing
SETUP <ENTER>. Press any key to display a list of supported applica-
tions. Use the arrow keys to select Lotus/Symphony, and press <EN-
TER>. A list of supported screen resolutions will be displayed. Use the
arrow keys to select the desired screen resolution and press <ENTER>.
(Make sure your monitor is able to display the resolution desired) Press
<END> to begin the driver installation process. A default drive and
directory path will be displayed. Use the backspace key to erase this
default and type in the 123 directory. At this point you may be asked to
create the target directory if it does not already exist. After the files have
been installed, press any key to return to the list of supported applica-
tions. Press <ESC> followed by Y to exit to DOS. Copy all the files that
were just created in the temporary directory onto a formatted floppy
diskette.
Step 2: Go to your 123 directory, and start the installation program.
Type the following commands:
C: <ENTER>
INSTALL <ENTER>
Step 3: The Lotus installation program will load and present the
installation menu. From this menu, select Advanced Options. From the
Advanced Options menu, select Add New Drivers To Library. From the
Add New Drivers Menu, select Modify Current Driver Set. From the
Modify Driver Set Menu, select Text Display. From the Text Display
menu, select one of drivers.
Step 4: After the selection of the appropriate VGA display driver, you
will need to exit this menu and return to the Main Lotus Installation
Menu. Do this by selecting Return To Menu.
Step 5: At the Main Lotus Installation Menu, select Save Changes.
64 PPC-100 User's Manual