Installing The 2.5" Hard Disk Drive (Hdd); Figure 4-2: Installing The Primary 2.5" Hdd - Advantech PPC-153T User Manual

4.3 Installing the 2.5" Hard Disk Drive (HDD)

You can attach one enhanced Integrated Device Electronics (IDE)
hard disk drive to the panel PC's internal controller which uses a PCI
local-bus interface. The advanced IDE controller supports faster data
transfer and allows the IDE hard drive to exceed 528 MB. The follow-
ing are instructions for installation:
1. Detach and remove the plastic rear cover and side panel.
2. There is a metal plate which holds the HDD to the upper right-
hand side of the metal shielding case. (See Fig. 4-2.) Remove the
two screws on the metal plate.
3. Pull the metal plate toward the outside of the unit, and remove it
from the two lugs of the shielding case.
4. Place the HDD on the metal plate, and tighten the four screws
from the bottom of the metal plate.
5. The HDD cable (1 x 44-pin to 1 x 44-pin) is next to the metal
plate. Connect the HDD cable to the HDD. The another end of the
HDD cable is connected to the PC board (CN16). Make sure that
the red/blue wire corresponds to Pin 1 on the connector, which is
labeled on the board. Plug the other end of the cable into the IDE
hard drive, with Pin 1 on the cable corresponding to Pin 1 on the
hard drive.
PPC-153 User's Manual
36
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Figure 4-2: Installing the primary 2.5" HDD

2.5" HDD
Metal plate
Lugs