Advantech PPC-100 Manual page 65

Step 1: Install Windows as you normally would for a VGA display. Run
Windows to make sure that it is working correctly. Then exit Windows.
Step 2: Place the display driver diskette in drive A. Type A: <ENTER>
to make this the default drive. Type SETUP <ENTER> to run the driver
SETUP program. Press any key to get to the applications list. Using the
arrow keys, select Windows Version 3.1 and press the <ENTER> key.
Press the <ENTER> key to select All Resolutions, and then press
<END> to begin the installation. At this point you will be asked for the
path to your Windows System directory (default C:\WINDOWS). When
the installation is complete, press any key to continue. Press <ESC>
followed by Y to exit to DOS.
Step 3: Change to the directory where you installed Windows (usually
C:\WINDOWS).
Step 4: Type SETUP <ENTER> to run the Windows Setup program. It
will show the current Windows configuration. Use the up arrow key to
move to the Display line and press <ENTER>. A list of display drivers
will be shown. Use the arrow keys to select one of the drivers starting
with an asterisk (*) and press <ENTER>.
Step 5: Follow the directions on the screen to complete the setup. In
most cases, you may press <ENTER> to accept the suggested option.
When Setup is done, it will return to DOS. Type WIN <ENTER> to start
Windows with the new display driver.
To change display drivers from DOS, change to the Windows directory
and run Setup, repeating steps 4 and 5 from the previous page. Besides
the special display drivers marked by an asterisk (*), you should be able
to use the following standard drivers:
VGA 640x480, 16 colors
Super VGA 800x600, 16 colors
60 PPC-100 User's Manual