Installing The System Software - Advantech PPC-L60T User Manual

The settings you specify with the setup program are recorded in s
special area of memory called CMOS RAM. This memory is
backed up by a battery so that it will not be erased when you turn
off or reset the system. Whenever you turn on the power, the
system reads the setting stored in CMOS RAM and compares
them to the equipment check conducted during the power on
self-test (POST).If an error occurs, an error message will be
displayed on screen, and you will be prompted to run the setup
program.

2.4 Installing the system software

Recent release of operating systems include setup program which
automatically load and guide you through hard disk preparation
and operating system installation. The guidelines below will help
you determine the steps necessary to install your operation system
on the Panel PC hard drive.
Note: Some distributors and system integrators may have already
pre-installed system software prior to shipment of your Panel PC.
Installed software requires an installed HDD. Software can be
loaded in the PPC-L60T using any of two methods.
2.4.1 Method 1: Use the Ethernet
You can use the Ethernet port to download software to the HDD.
2.4.2 Method 2: Use the COM
You can use the Lap Link 6 or similar transmission software.
Connect another PC to the PPC-L126 with an appropriate cable
and transmit the software to the PPC-L126.