Installing A 3.5" Hdd - Advantech IPPC-9151 Series User Manual

2.4 Installing a 3.5" HDD

You can attach one enhanced Integrated Device Electronics (IDE) hard
disk drive to IPPC-9151's internal controller which uses PCI local bus
interface. The following instructions are for installation:
1. Unlock the back cover and open it.
2. Remove the two screws and take off FDD, CD-ROM Module.
3. Remove four screws and take off HDD bracket.
4. Insert the HDD into the bracket (see figure 2.4.3)
5. Put the HDD bracket into the Chassis and fasten the four screws.
Then attach the HDD flat cable and power cable.
IPPC-9151 Series Users Manual 16