Driver Installation - Advantech PPC-100 Manual

These drivers are designed to work with Autodesk AutoCAD R12. They
conform to the Autodesk Device Interface (ADI) for Rendering drivers
and Display drivers. These display list drivers accelerate redraw, pan,
and zoom functions.
Step 1: Place the display driver diskette in drive A. Type A: <ENTER>
to make this the default drive. Type SETUP <ENTER> to run the
SETUP program. Press any key to get to the applications list. Using the
arrow keys, select AutoCAD Release 12 and press <ENTER>. This will
display a list of supported driver resolutions. Using the arrow keys and
the <ENTER> key, select the resolutions that are appropriate for your
monitor. When all of the desired resolutions have been selected, press
<END> to begin the installation. At this point you will be asked for a
drive and directory to copy the driver files. Enter the drive and directory
that contains the installed AutoCAD R12. If the destination directory
does not exist you will be asked for confirmation. When the installation
is complete, press any key to continue. Press <ESC> followed by Y to
exit to DOS.
Step 2: Go to the AutoCAD directory where the new drivers were
installed and run the driver installation program by typing ACAD12 -r
<ENTER>. This program will configure your AutoCAD R12 to use the
new display drivers. Select TurboDLD Classic.
Select Configure Video Display. In Display Device Configuration
choose Select Graphics Board/Resolution. Then choose Select Display
Graphics Board. After choosing a graphics board, go to Select Display
Resolution. After selecting the display resolution, save the new configu-
ration, and return to the main menu.
62 PPC-100 User's Manual