Table of Contents
Advertisement
The PPC-100's on-board Boot ROM have been written to the ROM BIOS
chip. If you want to change the settings, configure the software as
follows:
1. Power on the PPC-100 with a color TFT or Mono display attached.
This is the default setting for the PPC-100. Ensure that the
AWDFLASH.EXE and *.BIN files are located in the working drive.
NOTE:
Ensure that you do not run AWDFLASH.EXE while your
system is operating in with any memory management
software.
2. At the prompt, type AWDFLASH.EXE and press <Enter>. The VGA
configuration program will then display the following:
File Name to Program:
Error Message:
FLASH MEMORY WRITER v. 1.2
Copyright (c) 1993, Award Software Inc.
For VIA486A-310L200
Flash Type: For VIA486A-310L2AK
VGA Setup screen
08/23/96
Chapter 4 Software Configuration
49
Advertisement
Table of Contents
