Siemens SINUMERIK 840Di sl Function Manual page 42

2 Maschine information
2.2 Variable monitors - Measurements and measurement series
Where individual measurement diagrams are concerned, the "Actions" menu and
context menu have the same options:
Entries menu
Parameters
Supplementary condi-
tions
Comment
Scaling
Scaling for the equability test
Fig. 2-22: Scaling for the equability test
"Display" menu
This menu is only available for the individual measurement diagram of the
equability test.
Entries menu
All without ramps
All with ramps
Between the markings
Navigating to previous/next measurement
The two buttons for this function can be used to navigate to the previous or next
measurement of the measurement series in question.
2-42
Shows the pop-up window with the list of measurement
parameters. The same pop-up window can be opened
from the context of the time series.
Shows the pop-up window with the list of measurement
parameters.
Pop-up with measurement comment
Setting for the diagram scale (for the equability test
only). In the case of the diagrams for the circularity test
and universal axis test, the "Actions" menu does not
contain "Scaling".
Displays the entire measuring range, but without
the acceleration ramps
Displays the entire measuring range, including
the acceleration ramps
Adjusts the zoom factor of the diagram at the
area between the markings. This function
assumes that both of the markings have been
set.
ePS Network Services, Function Manual (FH) - Release 12/2008
© Siemens AG 2008 All Rights Reserved
12/2008