Siemens SINUMERIK 840Di sl Function Manual page 102

3 Setting up functions
3.4 Fault services
Field
Control monitors
Status (overall)
Common start date
New triggers
participation
PLC remaining
memory and
performance index
Exchanging addresses
in notifications
Next synchronization in
3-102
Content
Tree for selecting the control monitor
to be processed. It can be expanded
to show the triggers defined in it,
which can be jumped to directly.
Switches the currently active control
monitors on or off on the next
synchronization.
Note:
Does not change the activation state
of each monitor.
The common start date defines the
point at which all triggers will begin to
execute the control monitor. Each
trigger can be set so that it responds
to the start date. If a start date has not
been specified, all of the triggers react
to the common start date with the
reaction identification.
Specifying dates in the past is not
permitted. Dates that are no more
than 2 years in the future can be
specified.
Default setting for the function setting
for triggers: If an individual trigger
setting has not been made for
participation at the start date, the
triggers will respond at the start date.
Overview of the remaining memory of
the individual PLC blocks and
overview of the PLC performance
index currently in use and maximum
PLC performance index:
• PLC trigger configurations
• PLC trace configurations
• PLC data
An address that is configured in one
or more notifications of a control
monitor can be replaced by another
address from the organization's
address book.
Shows the time remaining until the
next synchronization: If
synchronization is overdue, negative
values are displayed.
ePS Network Services, Function Manual (FH) - Release 12/2008
Type
TREE
DISPLAY
SELECTION
DISPLAY
SELECTION
DISPLAY
SELECTION
DISPLAY
ACTION
DISPLAY
© Siemens AG 2008 All Rights Reserved
12/2008