Siemens SINUMERIK 840Di sl Function Manual page 132

3 Setting up functions
3.4 Fault services
Field
Type
Trigger
Interval
Remainder
[ ]
Delete
Add
Dependent on
start date
Each trigger can be assigned a label, which determines its behavior at the central
start date for maintenance (see also: Sub-section 6.1.3 "Machines"
and general description of triggers):
•
If a label has been set and a start date, which has not yet been reached, has
been configured in the master data, the trigger will not be initiated.
•
If the date has been reached or is in the past, the trigger will be initiated
according to the conditions set for it.
•
If a start date has not been configured, or the label has not been set, the
trigger will be initiated according to the conditions set for it.
Cyclic trigger on variable monitor
ePS Network Services restrict the use of variables for this cyclic server trigger to an
"endless counter" defined in the ePS Network Services.
The values read in a different control monitor action (execute variable monitor) can
be prompted in such a way that the trigger is initiated when a configured interval
value is reached or exceeded. The interval is then automatically projected onto the
interval grid for the next prompt.
3-132
Content
Counter status, corrected by ePS, for
current absolute variable content
Current status for the next initiation,
either specified by an entry or
automatically calculated and entered
by ePS Network Services at interval
change
Interval value
Numerical and graphic display of the
remaining count units until next
initiation
Unit of the counter
Deleting the counter from the server
trigger
Adds another NC variable counter to
the server trigger.
This label specifies the dependency
of the start date for maintenance.
ePS Network Services, Function Manual (FH) - Release 12/2008
Type
DISPLAY
DISPLAY
INPUT
(With ePS Network
Services update)
DISPLAY
INPUT
(Up to a max. of
9 digits)
DISPLAY
DISPLAY
ACTION
ACTION
DISPLAY
SELECTION
(Toggle)
Master data,
© Siemens AG 2008 All Rights Reserved
12/2008