Installation
While your installation partner is supporting the system's weight, perform steps 3, 4 and 5:
On the rear side of the cabinet, install the two blades (B) in the selected rack unit, using four
Step 3.
M6 screws (C). Do not tighten the screws yet. See
Slide the two blades into the left and right rails, and adjust them to fit your rack's depth. Use
Step 4.
four M6 screws (D) to fix the blades into the rack. Do not tighten the screws yet. See
Secure the system in the rack by tightening the 8 screws inserted in Step 3 and Step 4 with a
Step 5.
torque of 4.5±0.5 Nm.
Figure 25: Installing the Cage Nuts
Figure 26: Attaching the Rails to the Rack
Figure 27: Sliding the Blades in the Rails
Figure
26.
Mellanox Technologies
Rev 1.2
Figure
27.
31