HP ProCurve 5300xl Series Management Manual page 592

Router Redundancy Using XRRP
Displaying XRRP Data
HPswitch(config)# show xrrp statistics instance 1 5
Statu s and Counters - XRRP Virtual Router Statistics Information
Owne r Router Number : 1
VLAN ID
Oper ational State
Up T ime
Pkts Rx
Zero Priority Rx
Bad Version Pkts
Mism atched IP Pkts
Figure 12-12.Example of Output for Show XRRP Statistics Instance [<owner-router-number> <vlan-id>]
HPswitch(config)# show xrrp statistics router 2
St atus and Counters - XRRP Router Coordinator Statistics Information
R outer Number : 2
B ecome Master : 1
M aster Time
T ype1
P kts Rx
- ----------- ------------ -------- ---- ------------ ------------
0
Figure 12-13.Example of Output for Show XRRP Statistics Router <router-num>
12-20
The keyword instance can be used to display statistics information for the
virtual router instance(s) on the switch. If no parameters are specified after
this keyword, the information for all virtual routers is displayed, otherwise
the information for the particular virtual router is displayed by specifying the
owner-router-number and the vlan-id in the command. In the example below,
the statistics information for the virtual router number 1 on VLAN 5 is
requested.
: 5
: Master
: 64 mins
: 0
: 0
: 0
: 0
The keyword router can be used to display statistics information for the
specific router coordinator operating in the XRRP domain as shown in the
next example.
: 76 mins
Type 1
Pkts Tx
924
Pkts Tx
Zero Priority Tx
Mismatched Pswd Pkts
Mismatched Interval Pkts : 0
Type2 Typ e2
Pkts Rx Pkt s Tx
0 0
: 780
: 0
: 0
Unknow n
VLAN I D
0